Quick answer: For resistance band arm exercises, most people need 10–20 kg for two-armed bicep curls and 15–30 kg for two-armed tricep pushdowns. Triceps take more than biceps because they are the larger muscle, and any two-armed movement needs roughly double the band a single-armed version does, since one band's tension is shared between both arms. Curls are done standing on the band; pushdowns and overhead extensions need a high or low anchor point.
Every guide to band arm training lists the same eight or nine exercises. Almost none of them tells you how much resistance to use, where to anchor the band, or what to do in week four that you weren't doing in week one. Here are all three.
How much resistance do you need for band arm exercises?
Biceps take 10–20 kg on two-armed movements and 5–10 kg single-armed; triceps take 15–30 kg two-armed and 5–15 kg single-armed. Arms are small muscles worked through a short range, so the numbers are much lower than the 30–60 kg a squat needs — but they are higher than the single light band most people reach for.
| Exercise | Anchor / setup | Starting resistance | Sets and reps | Rest |
|---|---|---|---|---|
| Two-handed bicep curl | Stand on band | 10–20 kg | 3 × 12–15 | 60 sec |
| Hammer curl | Stand on band | 10–20 kg | 3 × 12–15 | 60 sec |
| Drag curl | Stand on band | 10–15 kg | 3 × 12 | 60 sec |
| Single-arm curl | Stand on band, one foot | 5–10 kg | 3 × 12 per arm | 45 sec |
| Behind-the-body curl | Door anchor, low | 5–10 kg | 3 × 12–15 per arm | 45 sec |
| Two-arm tricep pushdown | Door anchor, high | 15–30 kg | 3 × 12–15 | 60 sec |
| Single-arm pushdown | Door anchor, high | 5–15 kg | 3 × 12 per arm | 45 sec |
| Overhead tricep extension | Door anchor, low, facing away | 10–20 kg | 3 × 12–15 | 60 sec |
| Band skull crusher | Door anchor, low, lying | 10–20 kg | 3 × 10–12 | 60 sec |
| Tricep kickback | Door anchor, low | 5–10 kg | 3 × 12–15 per arm | 45 sec |
Treat those as a first session rather than a prescription. The test that overrides the table: if the last two or three reps of a set aren't difficult while your form stays clean, go heavier.
Why do triceps need more resistance than biceps?
Because the triceps is the bigger muscle — three heads to the biceps' two, making up most of the mass of your upper arm — and because the pushdown position gives it better leverage than a curl gives the biceps. Loading both at the same weight, which is what most band arm workouts implicitly do by using one band for the whole session, means one of them is being undertrained.
As a working rule, whatever band makes your curls hard, expect to need about one and a half to two times that for pushdowns.
There is a second piece of arithmetic that catches people out, and no other guide to this exercise mentions it:
A two-armed movement needs roughly double the band a single-armed one does. When you pull one band with both hands, the band's tension is split between your two arms — each arm gets about half. So a 20 kg band in a two-arm pushdown gives each arm roughly the work a 10 kg band gives it single-armed. If you move from two-arm to single-arm work and keep the same band, you have just doubled the load on that arm without meaning to.
This is also why single-arm numbers in the table above look so low. They aren't lighter sessions — they're the same load, counted per arm.
Where does the band load your arms hardest?
At the end of the movement, because a band's tension climbs as it stretches. In a curl that means the top, with your hands at your shoulders. In a pushdown it means lockout, with your arms straight.
Both of those are the positions where the muscle has its best leverage, which is the point. It also means the start of each rep is the lightest part, so set up with the band already taut before you begin — if there's slack at the bottom of a curl, the first third of every rep is doing nothing.
How do you set up band arm exercises?
Curls are done standing on the band. Everything for triceps needs an anchor, and the anchor height is what changes the exercise.
Standing on the band (curls). Both feet on the centre of the band, holding the ends or a bar. Widen your stance to increase resistance without changing bands.
Door anchor, high (pushdowns). Anchor at the top of a closed door and face it. The band comes down at an angle onto your elbows, which is the position the triceps is strongest in.
Door anchor, low, facing away (overhead extensions). Anchor at floor level, step forward and turn your back to the door, then press upwards from behind your head. Keep your elbows tucked and pointing forward rather than flaring.
Door anchor, low, lying (skull crushers). Anchor at floor level and lie with the top of your head toward the door. Only your forearms move.
A two-handed bar is worth using for curls specifically — it keeps both hands at a fixed width, so one arm can't quietly take more than the other. The AEVO handles hold 100 kg each, which is far more than any arm movement will ask of them, and the door anchor is rated to 120 kg.
The best resistance band bicep exercises
1. Two-handed bicep curl. Stand on the centre of the band, feet hip-width, holding a bar or a handle in each hand with palms forward. Keep your elbows pinned to your sides and curl to shoulder height. Lower over two to three seconds. 10–20 kg, 3 × 12–15.
2. Hammer curl. As above, palms facing each other throughout. Hits the brachialis, which sits under the biceps and makes the arm look thicker from the side. 10–20 kg, 3 × 12–15.
3. Drag curl. Standing on the band, drag your hands up the front of your torso, letting your elbows travel backwards rather than staying pinned. Shorter range, more tension at the top. 10–15 kg, 3 × 12.
4. Single-arm curl. One foot on the band, one handle. Lets you match a weaker arm to a stronger one rather than hiding the difference. 5–10 kg, 3 × 12 per arm.
5. Behind-the-body curl. Anchor the band low and stand a step in front of it, so your arm hangs slightly behind your hip. Curl from there. The stretched starting position loads the long head of the biceps harder than any standing curl. 5–10 kg, 3 × 12–15 per arm.
The best resistance band tricep exercises
6. Two-arm tricep pushdown. Anchor high, face the door, elbows at your sides. Push down until your arms are straight, pause for a beat at lockout, and return under control. The heaviest of the arm movements. 15–30 kg, 3 × 12–15.
7. Single-arm pushdown. Same setup, one hand. Useful for fixing a side-to-side difference. Remember the halving rule — use roughly half the band you'd use two-armed. 5–15 kg, 3 × 12 per arm.
8. Overhead tricep extension. Anchor low, turn away from the door, hands behind your head, elbows forward. Press up until your arms are straight. The overhead position stretches the long head of the triceps, which the pushdown doesn't. 10–20 kg, 3 × 12–15.
9. Band skull crusher. Anchor low, lie on your back with your head toward the anchor, upper arms vertical. Bend only at the elbow, lowering your hands toward your forehead, then extend. 10–20 kg, 3 × 10–12.
10. Tricep kickback. Anchor low, hinge forward at the hips, upper arm parallel to the floor and fixed. Extend at the elbow until the arm is straight, squeeze, return slowly. 5–10 kg, 3 × 12–15 per arm.
A six-week arm progression
Arms recover quickly, so twice a week works well. Keep at least 48 hours between sessions. Each session runs about 20 minutes and can be added to the end of an upper body day.
| Weeks | Session A | Session B |
|---|---|---|
| 1–2 | Two-handed curl 3 × 15 (10–15 kg) · Two-arm pushdown 3 × 15 (15–20 kg) · Hammer curl 3 × 12 (10–15 kg) · Overhead extension 3 × 15 (10 kg) | Single-arm curl 3 × 12/arm (5 kg) · Single-arm pushdown 3 × 12/arm (5–10 kg) · Kickback 3 × 15/arm (5 kg) |
| 3–4 | Two-handed curl 3 × 12 (15–20 kg) · Two-arm pushdown 4 × 12 (20–25 kg) · Drag curl 3 × 12 (10–15 kg) · Skull crusher 3 × 12 (10–15 kg) | Behind-the-body curl 3 × 12/arm (5–10 kg) · Single-arm pushdown 3 × 12/arm (10 kg) · Hammer curl 3 × 15 (15 kg) |
| 5–6 | Two-handed curl 4 × 10 (20 kg) · Two-arm pushdown 4 × 10 (25–30 kg) · Overhead extension 3 × 12 (15–20 kg) · Drag curl 3 × 15 (15 kg) | Behind-the-body curl 3 × 15/arm (10 kg) · Single-arm pushdown 3 × 12/arm (10–15 kg) · Skull crusher 3 × 12 (15–20 kg) · Kickback 3 × 15/arm (10 kg) |
Move up a band the moment the final reps stop being hard, rather than waiting for the next block.
Why your band arm workouts stall
One band for the whole session. The most common problem by a distance. Your triceps and biceps do not want the same resistance, and using one band for both guarantees at least one of them is coasting.
Elbows drifting. In curls and pushdowns alike, the elbow is meant to be a hinge that stays put. Once it starts travelling, your shoulders and back take over the work.
Slack at the start of the rep. Arms move through a short range, so losing the first third of it to a loose band costs proportionally more here than anywhere else. Step wider, or move further from the anchor.
Only ever pushing down. The pushdown trains the triceps in one position. The overhead extension trains the long head in a stretch, which nothing else in the session does. Keep both.
Frequently asked questions
How much resistance do I need for band bicep curls? 10–20 kg for a two-handed curl, 5–10 kg for a single-arm curl. If the last two or three reps of a set aren't difficult, go heavier. Single-arm numbers look lower because they are counted per arm, not because the set is easier.
Do triceps need heavier bands than biceps? Yes, usually by about one and a half to two times. The triceps has three heads and makes up most of the mass of the upper arm, and the pushdown position gives it better leverage than a curl gives the biceps. Using the same band for both is why one of them tends to stop progressing.
Can you build arm muscle with resistance bands alone? Yes. Muscle grows in response to mechanical tension and sets taken close to failure, and bands supply both as long as the resistance is high enough and you keep adding to it. Arms are among the easiest muscles to train this way, because the loads involved are well within what a stackable band set covers.
Where do you anchor a band for tricep exercises? High on a closed door for pushdowns, and at floor level for overhead extensions, skull crushers and kickbacks. The anchor height is what changes which part of the triceps does the work, so it's worth moving the anchor rather than doing every tricep movement from the same position.
How often should you train arms with bands? Twice a week, at least 48 hours apart. Arms recover quickly and the sessions are short, so they sit well at the end of an upper body day rather than needing their own slot.
Getting started
Arm training with bands falls down for one reason: one band, used for everything, too light for the triceps and eventually too light for the biceps as well.
The AEVO Strength System holds eight natural latex bands — 5, 10, 15, two at 20 and three at 25 kg — which combine to 145 kg. For arms that means you can set curls and pushdowns at different resistances in the same session, and keep moving both up independently. The silicone handles hold 100 kg each, the XL door anchor is rated to 120 kg and gives you the high and low positions the tricep movements need, and the two-piece steel bar keeps both hands fixed for curls. The kit is $199.99 AUD with a lifetime warranty and a 60-day return window.
For the pressing work that trains triceps alongside chest, see Resistance Band Chest Exercises, and for two-handed bar work across the whole body, see Resistance Band Bar Exercises.
This article is general fitness information, not medical advice. Band arm work loads the elbow, shoulder and wrist. If you have a current or previous injury to any of those, including tennis or golfer's elbow, check with a doctor or an accredited exercise physiologist before starting. Stop any exercise that causes pain rather than effort.