Start a banded seated row at 25 kg for 3 sets of 12, resting 60 to 90 seconds between sets. Run the band through a door anchor set low, sit on the floor facing the door with your legs extended and far enough back that the band is already taut with your arms straight, then pull your hands to your torso and squeeze. That 25 kg is the heaviest starting load published for any upper-body compound in the AEVO system — heavier than the bent-over row, the chest press and the overhead press — and there are two reasons for it, one of which nobody writing about this movement mentions.
Why does the seated row take the heaviest band of any upper-body compound?
Here are the published starting loads for the four two-handed upper-body compounds in the system, side by side:
| Movement | Setup | Starting resistance | Sets × reps |
|---|---|---|---|
| Seated row | Door anchor, low | 25 kg | 3 × 12 |
| Bent-over row | Bar, standing on the band | 20 kg | 3 × 12 |
| Chest press | Door anchor at chest height, behind you | 20 kg | 3 × 10–12 |
| Overhead press | Bar, standing on the band | 15 kg | 3 × 10 |
The first reason is the one our bent-over row guide gives: sitting down removes the hinge. In a bent-over row your hamstrings and lower back hold a hinged position for every rep, and that holding job — not your mid-back — is usually what fails first. On the floor, the floor does it for you. Same muscles rowing, less machinery holding you in place, so the band can be heavier before your form gives out.
The second reason has not been written down anywhere, and it is the more interesting one. The seated row is the only row in the system where the band pulls along the same line your hands travel. Stand on a band and hinge over for a bent-over row and the band runs upward from your feet while your hands travel backward to your ribs — the two directions sit at an angle to each other, so a centimetre of pull buys you less than a centimetre of stretch. Sit down with a low anchor in front of you and the band's line and your hand path are the same line. Every centimetre your hands travel is a centimetre of stretch, and all of it lands on the muscles doing the rowing.
That is why the number is 25 and not 20. It is not a harder movement than the bent-over row; it is a more efficient one. The band's whole working range goes into the pull instead of being spread across two directions at once. Our hamstring guide names the three things that set the load on any band movement — how much muscle is sharing the work, how good your leverage is in that position, and how many limbs the tension is divided between. Both rows are two-armed and both use the same muscles, so the first and third are identical. The whole 5 kg difference sits in the second one, and it splits into those two parts: what is holding you up, and where the band is pointing.
How do you set up a resistance band seated row?
The setup takes about twenty seconds once you have done it twice. Thread the door anchor through the hinge side of a door, close the door fully against it so it opens away from you, and let the strap hang at floor level. Loop one band through the anchor and clip both ends to your handles with carabiners, or to both eyelets of the bar if you want a fixed hand position — rows from a door anchor are one of the movements that need only handles and an anchor, so the bar is optional here in a way it is not for a bent-over row.
Sit on the floor facing the door with your legs extended and a soft bend in the knees. Now set your distance: slide back until the band is already taut with your arms straight out in front of you, before you pull anything. This is the single thing most people get wrong. Sit too close and the first part of every rep is spent taking up slack, which wastes the easiest and most controllable part of the range. With the band taut from the start you feel the resistance immediately and the whole pull counts.
From there, pull your hands to the sides of your torso, elbows tracking close to your ribs rather than flaring wide, shoulder blades drawing together at the finish. Hold for a beat at the back. Let your arms straighten under control rather than letting the band snap you forward — the return is half the work. Keep your chest tall and your lower back from rounding; if your torso is being dragged forward at the end of a set, that is your signal to stop the set, not to lean into it.
Where is a banded seated row hardest?
At the finish, with your hands at your torso and your shoulder blades squeezed together. You feel the tension as soon as the band is taut, and it climbs as the band stretches, so the heaviest moment of every rep is the moment your hands are closest to you.
This is worth saying plainly, because a lot of writing on band rows claims a band gives even resistance throughout the movement. It does not, and the fact that it does not is the best thing about this exercise. Full retraction — hands at the ribs, blades together — is exactly where the rhomboids and mid-traps do their work, and it is the position almost everybody under-loads. A cable row gives you the same resistance at the finish as at the stretch. A band gives you the most resistance precisely where the muscle you are training is strongest and most able to use it.
Two practical consequences. First, choose your band by whether the last two reps of the set are genuinely hard at the finish — not by how the first rep feels at full stretch, where every band feels light. Second, a pause at the back is the cheapest progression available on this movement, because it holds you at the heaviest point of the curve rather than the lightest.
What does a six-week seated row progression look like?
Add reps for two weeks, add reps again for two more, then move up a band and drop the reps back. That is the same progression the rest of the system runs on, and it works because the band ladder gives you measured steps in kilograms instead of a vague instruction to go heavier.
| Weeks | Sets × reps | Resistance | Rest |
|---|---|---|---|
| 1–2 | 3 × 12 | 25 kg | 60–90 sec |
| 3–4 | 3 × 15 | 25 kg | 60–90 sec |
| 5–6 | 4 × 12 | 30 kg | 60–90 sec |
The jump to 30 kg is the 25 kg band with the 5 kg band added through the same anchor. Because every band carries its own rating, the increment is a number you choose rather than a guess, and the ladder keeps going from there — 25 plus 10, 25 plus 15, and on up. Move when the last set still finishes cleanly at your torso, not on the calendar. If week three feels the same as week two, you were ready a week earlier.
How does the seated row fit into a programme?
Pair it with the bent-over row rather than choosing between them. They load the same muscles from different positions and with different limits — one trains your mid-back while your hips hold a hinge, the other trains it with the hinge taken out of the equation entirely, which is what lets it carry more band. Our bar exercise guide runs both on the same pull day, and the full body workout has the seated row in its horizontal pull slot with the published load and setup.
If you are starting from nothing, the four-week beginner programme is the better entry point and builds up to loads like these. The overhead press is the natural push to pair against it on the same session, and a core movement finishes the session off well.
Frequently asked questions
How much resistance do you need for a banded seated row?
Start at 25 kg for 3 sets of 12, resting 60 to 90 seconds between sets. That is a single 25 kg band through a low door anchor, clipped to both handles or to both eyelets of the bar, and it is the published starting figure for this movement. Move to 30 kg when 15 reps still finish cleanly with your hands at your torso.
Do you need a bar for a seated row with a resistance band?
No. The seated row is one of the movements that works with handles and an anchor alone, which is why it is a good first movement for anyone who has not assembled the bar yet. The bar is still worth using if you have it, because a rigid bar fixes your hand position so both sides are loaded evenly and the pull repeats the same way set after set, but unlike a bent-over row the movement does not depend on it.
How far from the door should you sit for a banded seated row?
Far enough back that the band is already taut with your arms straight out in front of you and your shoulder blades relaxed forward, before the first rep begins. There is no single distance that works for everyone because it depends on your height, your arm length and which band you are using, so set it by feel each session — take up the slack, then start. If the first inch of the pull feels like nothing, slide back.
Is a banded seated row as good as a cable row?
For the mid-back it is arguably better placed. A cable holds the same resistance all the way through the pull, while a band peaks at full retraction, which is where the rhomboids and mid-traps actually do their work and the position most people never load properly. A cable stack still wins on absolute load for a very strong lifter, but the two are complementary rather than ranked, and the band loads the end of the pull in a way a cable cannot.
Can you do a seated row with a resistance band and no door anchor?
Yes, with one change. Sit with your legs extended, loop the band around the soles of both feet, and hold one end in each hand — your feet become the anchor. It is a usable travel version of the movement, but your feet sit closer to you than a door does, so the stretch available is shorter and the published 25 kg figure no longer describes what you are holding. Treat it as the version you do away from home rather than the one you progress.
Should you do the seated row or the bent-over row?
Both, on the same pull day, and in that order if you only have the energy to do one of them well. The seated row carries the heavier band and trains the mid-back with nothing else competing for your attention, so it earns the first slot while you are fresh. The bent-over row then adds the hinge back in, which trains your hips and lower back to hold a position under load — a job worth training on its own terms.
Getting set up
A banded seated row needs three things: a low anchor point that will not move, a band heavy enough to be hard at full retraction, and a way to hold it evenly in both hands. The AEVO Strength System covers all three — eight natural latex bands from 5 kg to 25 kg that combine to 145 kg, an XL door anchor 7 cm in diameter rated to support up to 120 kg, two silicone handles rated to hold 100 kg each and measuring 14.5 cm wide, a two-piece steel bar that assembles to 106 cm from two 53 cm sections and is rated to support up to 200 kg with rotating eyelets, four stainless steel carabiners, padded ankle straps and a travel bag, plus AEVO Fit+ with five programmes and over 100 exercises. It is $199.99 AUD against an RRP of $349.95, with a limited lifetime warranty and 60 days to change your mind. Shipping costs are calculated at checkout based on your location, and Australian and New Zealand orders arrive 3 to 10 business days after dispatch.
This article is general fitness information, not medical advice. If you have a back, shoulder or elbow injury, or you are returning to training after a break, check with a qualified health professional before starting. Loads and progressions are starting points, not prescriptions — adjust them to your own experience and form.